jvaliensi
Active User
Hi there,
I have a sailplane with a full-flying stab. It rides on a 1/8" carbon rod joiner and has a steel pin thru the bellcrank and stab halves. It slides off too easily. I think after a few rolls a stab half may slide off in flight.
Are there any good tricks to keeping it on better?
I have a sailplane with a full-flying stab. It rides on a 1/8" carbon rod joiner and has a steel pin thru the bellcrank and stab halves. It slides off too easily. I think after a few rolls a stab half may slide off in flight.
Are there any good tricks to keeping it on better?