XAct servo telemetry on Ethos

[yufasa]

So I have to 5402H servos and have them configured and working fine on FBUS.
Working as in moving, however I am unable to get any telemetry from them at all.
I have hooked just one directly to the receiver and scanned for new telemetry and got nothing.
I am using an Archer RS with the port set to FBUS.
I have also tried it with my new RB-25S and pins 1-6 set to FBUS. again the servos operates fine in any of those but I cannot get any telemetry.
Not sure where I am going wrong but I am sure someone here will point me in the right direction

 

[yufasa]

I have updated the firmware on the servo's and receivers - also tried my SR8-Pro and still absolutely nothing other than the standard receiver telemetry.
I am not getting any telemetry from the servo's.

 

[yufasa]

Well, I got it working but sadly I don't know why/how...
It may have something to do with having 7 Archer RS receivers laying on the table but surely I could not have lost track of the one with the FBUS configuration...right?
I can also confirm that updating to latest firmware is an absolute must - some weird things happen if you don't.

Now I can see that one of my servos is/are? showing temp hotter than the other just sitting on the table - not sure what is up with that... sensor calibration off by 8-10 degrees?? that seems a lot.

Also another question: if I do need to replace gears, where do I get them - a casual search do not show anything. Don't need any but from experience I know that sometime in the future I may just need some...

 

[Wayne]

Let me know if you need any ever and I'll see if I can get them for you.