X18S + Neuron 60s + rxsr - telemetry???

[fiveflat]

I'm new to FrSky so ethos is all I know so far and barely at that.
I was able to spend an entire weekend muddling through the ethos menu and got my model setup with all my flight modes and idle ups.

In addition to all the FrSky items I have listed I'm connecting it all to an iKon2 FBL.
Now I'm trying to move on to telemetry. I soldered a wire onto the Bpad of the rxsr and have it running straight to the signal of the SAT-1 port. The S.port wire is going to the signal pin of CH3.

On my X18S I can discover new sensors and I get a handful of telemetry items as I expected but some that I am not. Specifically ESC voltage, which the Neuron 60s is supposed to be capable of. I'm not sure what I'm doing wrong or where I'm not looking on the internet to help me but I'm having a heck of a time. I don't even know how to run lua scripts (or what they even are) I found an integration script provided by MSH-electronics (iKon2/Brain2) for the X18/X20 and the instructions for installing that script don't match up with my X18S...

 

[gnichola]

I am not quite following your wire connection setup, so I can't say if you have it right or wrong, however what I will say is this. The receiver by itself will throw off things like rssi, rx bat, and a couple others, so you get those just by powering up the receiver. To get data from the Neuron, you need only run a sign
al wire from the Neuron to the SPort pin on the receiver like in this image below. You don't actually need the neutral line. After doing that, you should see all the Neuron telemetry, rpm, temp, current (motor and radio), voltage, etc.