X10/S Battery availability for a project

[dang]

I'm convinced that the thermistors are not required as well. That said the center wire to the internal charger needs some kind of information or the green charging light just blinks forever. Perhaps those PCBs I got have on board thermistors. In any event, I had to connect the center tap to internal charger to the pad marked "T" for it all to work.

 

[profumodelmosto]

Transitioning from A&P to UAS tech, so I finally have some off time to tinker again.
Had these little guys waiting for me.
View attachment 809
Hopefully I'll have a test pack soldered up later today. I didn't find the thermistors I ordered in the mail, so still waiting on those. All the info I could find about them points toward standard 10k so I may just try using my printer spares and see what happens.

My favorite Nylon is carbonX from 3dxtech. Bit pricey but the strength and finish is just amazing. I run a tungsten nozzle for it and so far the only downside is that nylon doesn't bridge well at all, requiring higher infill settings.

 

[profumodelmosto]

Hi guys, please help me. Where can I find protection board 2s to upgrade battery of my Horus x10?

 

[Wayne]

We have some in stock here. I think you already emailed us about them...

 

[MikeyC38]

I know this is an old thread BUT Wayne do you keep any of these thermistor controlled 2S protection boards in stock or know where I can source these from? I'm in the UK and my battery pack on my 2018 Horus X10 is dying...

 

[Wayne]

Sorry - We do not anymore. Maybe T9 in the UK has some kicking around? What we have done in the past is just replace the battery cells, reusing the existing board.