Turnigy 9x w/ Frsky XJT module - channel mapping issues

[SF-FPV]

Hello,

I've been trying to figure this out for a while to no avail. I installed the XJT Module on my Turnigy 9x and within my KISS FC GUI my channels are in correct. I had a previous user on Rcgroups.com tell me to fix my channel mapping on the KISS GUI but there isn't a way to do that. At least w/ the KISS FC I have (v1...). Any ideas? I'm out of ideas.

Turnigy 9x Radio
Frsky XJT Module
Frsky R-XSR receiver
KISS V1 FC

Here is the way my channels are mapped currently which is incorrect:

-Throttle controller input=pitch FC input
-yaw controller input =yaw FC input = Correct
-pitch controller input=roll FC input
-Roll controller input =throttle FC input

It didn't do this before I put the module and new receiver in. Any ideas would be appreciated. Thanks!

Bill

 

[Nigel]

I don't use KISS GUI often, as it is quite restrictive and limited. You cannot change the channel mapping in the GUI, you will have to do it radio side in your mixer page on OTX radios, honestly can't say I've ever tried that on or used a Turnigy radio.

 

[SF-FPV]

Thanks Nigel. You can't mix channels on Turnigy 9x. It's too basic... It's funny, I got KISS to make things easier and now it won't work. I found a link on how to install Betaflight, which I've used before. That, or I have to buy a new radio which is probably a good idea in the long run. Thanks again.

 

[HENNY]

Everything has a use by date.

 

[RafaelAvila]

Thanks Nigel. You can't mix channels on Turnigy 9x. It's too basic... It's funny, I got KISS to make things easier and now it won't work. I found a link on how to install Betaflight, which I've used before. That, or I have to buy a new radio which is probably a good idea in the long run. Thanks again.

Try to flash open tx in your radio will be work perfectly