Trying to register SR10 tp x20

[Txmustangflyer]

Its not kicking. Both red and green LED's active on rx. Nothing happens. No active registration etc. X20 just sits there saying "register".
1. How long should it take?
2. I've given it 10 minutes.

 

[HENNY]

The Archer SR10 is an "ACCESS" only receiver. Is your TX switched to ACCESS mode. So to register hold down the bind button and power up holding the bind button for an additional second, both the red and green leds should be on solid. Ensure you have selected a new unused model number on your TX. If all this is done the TX response is almost instantaneous.

 

[Txmustangflyer]

I muddled through it..its now registered and bound. Building paused for the day..more Makers Mark than common sense at this point lol.