I have a SR10 + Ver 3.03 bound to an X18 (current firmware). I am using an FrSky 4 channel Sbus decoder was testing my failsafe and when I turned off the X18, everything did what it was supposed to. So far, so good. However, when I turned the radio back on, all the normal channels came back, but the 4 channels hooked to the decoder moved to their extreme limit and stopped dead.
Obviously failsafe is not going to do any good if the aircraft goes out of control when the link is recovered.
I have one of the pins assigned as SBus out...but never did touch the setting for that channel (not pin).
Any ideas?
Obviously failsafe is not going to do any good if the aircraft goes out of control when the link is recovered.
I have one of the pins assigned as SBus out...but never did touch the setting for that channel (not pin).
Any ideas?
