Redundancy Receiver setup

[Woodstock1]

Basically when you have a redundant receiver plugged into the primary receiver via S-Bus, the primary receiver then monitors the signal coming from both primary and secondary receiver. If/when the signal from the primary goes low, it fails over to the signal from the redundant receiver. Though I didn't specifically try it, I can't imagine why the telemetry would stop coming.
Both receivers are paired and I used channels 1-8 on both.

But we’re minds which is over I will use primary receiver telemetry which caused me to run a battery dead on an electric plane how can I fix this. Kiwi4

 

[bnourai]

so i am setting up the same M+ with gr8 can you all please post a picture of wiring.
thank you
Ben

 

[gnichola]

so i am setting up the same M+ with gr8 can you all please post a picture of wiring.
thank you
Ben

First, how many places are you going to post this question?
The GR8 has a full size SBus in plug, so take a regular servo type lead and solder the other end to the M+ with the signal lead going to SBUS OUT, the middle power lead going to VIN, and the ground lead going to GND.

 

[bnourai]

Thank you very much. Just did not know where is the right place..lol

 

[jgill450]

I'm thinking of using a R6 Archer with my SR10 Pro for redundancy. I am using 8 channels on the SR10, will the R6 accommodate the other two channels?