Masterpiece
New User
- Joined
- Feb 24, 2018
- Messages
- 23
- Reaction score
- 1
Hi
I have a Taranis x9d and a G-RX6 rx and am having a troublesome time getting the rx to bind. The x9d has opentx 2.2.2 firmware flashed to the radio and the 2.2.2 bootloader is also updated to the radio from the loaded sd card from Aloft hobbies.
My process of binding is as follows:
Firstly, put the rx into bind mode by pressing on the bind / FS button whilst powering up to get the solid red and green leds (blue led on as normal)
Then putting the TX into bind mode from the model setup menu (set as D16, 1-16 channels, 18ms normal servo rate {all from the internal module, no external module used}).
The TX chirps away whilst trying to bind, but the receiver green and red leds stay solid (as i am looking for the red led to flash telling me that the bind is successful)
So is my bind technique correct or am i missing something in the procedure? I have tried binding by putting the TX in bind first and then powered up the RX next (same outcome)
HELP ME PLEASE
Regards
Glen
I have a Taranis x9d and a G-RX6 rx and am having a troublesome time getting the rx to bind. The x9d has opentx 2.2.2 firmware flashed to the radio and the 2.2.2 bootloader is also updated to the radio from the loaded sd card from Aloft hobbies.
My process of binding is as follows:
Firstly, put the rx into bind mode by pressing on the bind / FS button whilst powering up to get the solid red and green leds (blue led on as normal)
Then putting the TX into bind mode from the model setup menu (set as D16, 1-16 channels, 18ms normal servo rate {all from the internal module, no external module used}).
The TX chirps away whilst trying to bind, but the receiver green and red leds stay solid (as i am looking for the red led to flash telling me that the bind is successful)
So is my bind technique correct or am i missing something in the procedure? I have tried binding by putting the TX in bind first and then powered up the RX next (same outcome)
HELP ME PLEASE
Regards
Glen