FlyWing ATTi Mode

[vemadisonsr]

I am using a FRSKY Taranis Transmitter with OpenTx for my Flywing Helicopters. I am trying to setup the ATTi mode. Here are my questions:

1. Is there a video or tutorial that shows how to do it?
2. On the Flywing transmitter, the ATTi mode is at 1400 and 6G is at 1300. The OpenTx protocol uses percent travel so how do you set it for the correct value?
3. The controller flashes RED for the ATTi and 6G modes so how do you tell which mode you are in?
4. While on the ground, are there any physical differences between 6G and ATTi when you move the heli up, down or around?

 

[vemadisonsr]

The easiest way is to go to the Channel Output screen and adjust the endpoints for channel 5.