BEC voltage Neuron 40s and 60s using S.Port Airlink S

[DagsMords]

Hi all, I have watched the videos from ALOFT regarding the Neuron ESC's, great videos, but I cannot change or configure the Neurons using the Airlink APP Version 3.0.
I have used the BLHeli USB with no probs and works well, but I am trying to changed the Volts on the BEC using the S.Port Airlink, I am using Version 3 of the Airlink App, it connects okay with the Blue Tooth, and I have added Neuron 40s to my products list, but when I check the box next to the 40s and then tap config I get the 'no configuration items found' message. Any one else tried and was successful with V3.0 of the APP ?, I have a feeling FrSky have not added configuration tables in the APP for the 'Neuron S' as the Airlink works fine for my S8R and Archer S receivers, just no joy on the ESC's Thanks very much. Hoping someone can help.

 

[gnichola]

I have not tried with Airlink so I am not answering your question, but I am wondering if you had thought of using the Lua script to set it? I have used that with both the new40 and an original 80 and it worked great.

 

[Scott Page]

I don't know why using the airlink app is even a thing. I've many experiences with airlink since it's introduction. I'm not a fan. The LUA script is so easy for this there is need to make it complex by adding airlink. The same applies to configuring SxR receivers -- it's much easier using the LUA scripts and no additional hardware is needed. Only caveat is you need to have enough distance between Tx and Rx so that the signal does not swamp -- say 2 meters or so.