Archer SR6 with Taranis X9 Lite S telemetry limiting/throttling question

[Bartacus]

I recently tried to upgrade the firmware on my Archer SR6 RX from 2.1.6 to 2.1.9.

After upgrading, my Taranis X9 Lite S (OpenTX 2.3.12) experienced constant disconnect events. I was able to back down to 2.1.6 and the issue went away.

Is it possible that the new telemetry (Acc X/Y/Z sensor and Angle) values are flooding the communication?

Is there a way to limit/throttle the telemetry coming from the RX?

Or is this just a limitation of the X9 Lite S TX? (would this problem go away with a "better" TX?)

 

[Wayne]

Nope - don't think that was the issue. But I also am not aware of what your issue may be.

Disconnect events = failsafe??

 

[Bartacus]

The RX seemed to be responsive the whole time (servos never stopped working), this is probably better described as a constant telemetry lost/recovered cycle. RX signal bars disappear and reappear along with haptic feedback.

 

[Wayne]

Ahh, "telemetry lost" Telemetry Found"

Your transmitter is too close to the receiver. Separate them slightly, that should go away.