What's new
Aloft Forums

Welcome to Aloft Forums. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Archer Plus SR8 and Voltage Sensor (not working)

fryskyornot

New User
Maybe this has been posted, just didn't see it BUT I have a X20S TX running 1.6.2. I have one plane using a S8R rx with a voltage sensor that works fine. I have a L39 and using a Archer Plus SR8 rx (updated to 3.0.1). When I connect the voltage sensor and chk for all telemetry sensors, it does NOT see the sensor. the voltage sensor LED is rapid flashing, no matter what port on the sensor I use. I even tried it on the in and out port on the RX with no difference. Is there something I'm missing and where would it be??? Any help would be appreciated.
 
Maybe this has been posted, just didn't see it BUT I have a X20S TX running 1.6.2. I have one plane using a S8R rx with a voltage sensor that works fine. I have a L39 and using a Archer Plus SR8 rx (updated to 3.0.1). When I connect the voltage sensor and chk for all telemetry sensors, it does NOT see the sensor. the voltage sensor LED is rapid flashing, no matter what port on the sensor I use. I even tried it on the in and out port on the RX with no difference. Is there something I'm missing and where would it be??? Any help would be appreciated.
What port have you connected the voltage sensor to. You need to use the small white connector and connect to the pin labelled S-PORT and the positive and negative pins. Then go to model setup and click on discover sensors.
 
Thanks will do this. Luckily I do have this cable (didn't come with the sensor). I was connecting it to the port marked s.port-in, also tried s.port-out. Now will try the actual S-PORT.
 
Back
Top