Activation codes for S6R

[gorc]

Hi all, I'm new to this forum.

I have a problem getting the activation codes for my S6R receiver using UNI-Activate.lua script file.
I have successfully installed the UNI software in all my X8R, X6R and X4R receivers. The UNI software works great on all of them.
However with S6R I cannot get any activation codes coming out from the Activate.lua script.
I was successful installing the UNI_s6r_83sm.frk firmware into the S6R receiver. No problem there.
Then when I run the activate.lua script, nothing comes out, no codes, not even a LED is lit.
The hardware (cable between the rear of the Taranis plus and the S6R) has been the same and works fine for firmware download.
Any suggestions why this happens?
My first guess would be either Activate.lua or the 83 firmware have an issue for the S6R.

Please note I have reinstalled the latest FrSky firmware using the same cable to the S6R and it works great.

Please advise.
Best,

gorc

 

[MikeB]

No LED lit is odd.
With UNI flashed, if you power on with the bind button pressed, do you see the red LED lit, but blinking off every half a second?
When you then bind do you end with the green LED flashing?
If you then power the Rx off and on, with the Tx off, do you then get the red LED flashing slowly?

Mike

 

[gorc]

Hi Mike,

Let me try all this and will get back To you.

Gorc

 

[gorc]

Hi Mike,
I did another bind and now all works. I can get the activation codes from the activation script.
I'm sorry, I should have tried binding a second time and retry it. Maybe my first bind did not work?

Thank for your support.
gorc