taranis

Hello. Is there any hint how to parse more than 16 channels of SBUS protocol? My DIY drone is based on STM32.

So I recently switched from a Taranis X9D+ with an older version of OpenTX 2.0.9 !!! to a new X9D 2019 loaded with the latest OpenTX software 2.3.14, I also have an XJT module plugged in the back so I can bind with some of my older receiver, however some of the future that I really enjoyed using...

I recently tried to upgrade the firmware on my Archer SR6 RX from 2.1.6 to 2.1.9. After upgrading, my Taranis X9 Lite S (OpenTX 2.3.12) experienced constant disconnect events. I was able to back down to 2.1.6 and the issue went away. Is it possible that the new telemetry (Acc X/Y/Z sensor and...

Here's a short video - but my rudder and aileron movements do not go to the endpoints and/or behave erratically. I tried the calibration but essentially they behave the same way in the calibration too. I recently had to re-solder a wire on the right gimbal that had disconnected, and now it...

I'm looking at the baby Taranises TX and wondering how can I tell what model I'm looking at? I see no nomenclature or model badges on the case to differentiate the long list of various models. So, if my fellow hobbyist is trying to sell me a used X9-lite how do I know what he is selling? More...

I picked up a used taranis x9d+ on Craigslist for cheap - the owner said he thought the back board needed replacing. Could y'all help me confirm that? Here's the details: He described a situation where he failsafed and then the aircraft became unbound with his transmitter. He had several...

We had a customer with a Special Edition Taranis ask about using the X9E stubby antenna instead of the removable 2db antenna that comes stock on that radio. Why? The radio pretty much requires you to remove the antenna each time to store it in the travel case. Gets kind of annoying. (Note: We no...