Welcome to Aloft Forums. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Hi Wayne. I sent a message to Mike about this but no word back yet. I'm confused. S6R trying to use CH5 as normal output but receiving anything but normal from it. Here's a response from Jarron: I'm even more confused as I think FSK's are firmware for receivers not Scripts for setup. The top of the UNI page shows verson 84 is newest but then there is 85 and 87 and 87 is under a group called ETHOS.
I want to cut a new Alpina wing changing the airfoil to 3014 and adding flaps, and enlarging the ailerons. I have cut many sailplane wings in my past using a Feather cut foam cutter.
Sending this message to Wayne. I am ready to send my Frsky X20S radio into you for updating along with a couple of FrSky receivers. Where do I send it? Also I came across a article on RC Groups about a Multiplex Alpina 4000 you got from an estate. During a landing with my Alpina , it simply didn't want to land and a wing tip caught the ground and it cartwheeled ending its flying days!
Wayne:
This is my order AH-40096 with tracking N°UA466243193US, which hasn't arrived yet.
Can you tell me what is happening. I have send you emails with any look.
Hi Wayne, I am trying to connect 2 RX8Rpro receivers together so I have 16 pwm outputs. I have watched videos and still can not get it to work. any help would be awsome.
Hi Wayne
Hope you can help.
If I replaced my DHT wired into my MPX3030with the new XHT module and managed to find a FSD s port display (I'm assuming my old fld 02 display would have to go)would I still be able to use the telemetry of my old D8R series receivers?
Frsky say that the XHT is compatible with D8 but don't say anything about if telemetry can still be used in this configuration?
Thx, ordered the Flysky TX module...
Unit is too good to throw away and we need training systems so for this and some LiFe TX batteries we will be ready to go... after I learn how to program it and I have all the manuals for the TX